Best foam latex mix advice.
in Lab work
I’m newer to foam latex I’ve had a few successful runs and a few failed run. I’m currently using the monster makers foam latex kit and a SEEDEEM Electric mixer. I know it’s a little bit more powerful than the traditional ones and of course I have adjusted for that, I have also modified it so I’m able to back full with it as well.
It’s relatively hot where I do my work. I’m in New York but the basement I work in is around 72°
My current mix is speed one for 30 seconds
Speed five for three minutes
Speed two for five minutes
Adding agent speed two for 30 seconds
Back bowl throughout the process
Speed 1 for minute to refine
Sometimes this makes ratio firms up within 20 minutes and sometimes it takes a half hour to 45 minutes.
My current mix is speed one for 30 seconds
Speed five for three minutes
Speed two for five minutes
Adding agent speed two for 30 seconds
Back bowl throughout the process
Speed 1 for minute to refine
Sometimes this makes ratio firms up within 20 minutes and sometimes it takes a half hour to 45 minutes.
What should I adjust to help my phone with text pours be more successful.
The only problem that I run into is one specific area(the nose)
Sometimes doesn’t feel all the way I normally brush the foam into there and I make sure to get a good layer inside the nose and I also make sure to get foam inside the nose as well.
Sometimes doesn’t feel all the way I normally brush the foam into there and I make sure to get a good layer inside the nose and I also make sure to get foam inside the nose as well.
Normally, I wait until I’m able to touch the foam latex around the mold and it doesn’t stick to my finger But I know it’s supposed to normally harden up before putting it in the oven within 20 to 30 minutes.
0