Starting a new JASON :)

James Shaver · August 27

After having done Part 7 and Part 4 almost back to back i figured the clay gods had blessed me so i should keep on rolling forward...wanted to do the Winston Jason as i have only seen 1 other mask done of this and whereas it was good...its wasn't "movie representation" and i feel Stan did such an amazing job...I just wish io had more measurements and some better up close reference photos...a lot of these ( i think 10 of them) were pulled from the Internet so there's not any way i can zoom them up and print them ( I am not very computer literate these days_

Image: https://us.v-cdn.net/5020761/uploads/editor/s5/nplpc9qbiwty.jpg

Chris Ellerby · September 1

Looking good!

/Chris

James Shaver · September 5

Image: https://us.v-cdn.net/5020761/uploads/editor/e5/ew46sa5n0dnx.jpg

Image: https://us.v-cdn.net/5020761/uploads/editor/cq/7jvfeoud37aj.jpg

Image: https://us.v-cdn.net/5020761/uploads/editor/lq/2ywe06miaq49.jpg

Image: https://us.v-cdn.net/5020761/uploads/editor/2w/azpame2obf5w.jpg

Image: https://us.v-cdn.net/5020761/uploads/editor/d2/1d52rgq1phdz.jpg

Image: https://us.v-cdn.net/5020761/uploads/editor/0k/ybvv0oj74ar3.jpg

James Shaver · September 5

I basically have the right side finished but due to lack of clear and detailed photos i am kind of having to do a mashup of Part 3/4 on the back of the head...the one Winston photo where his head is shaped like a mushroom was a bit difficult to try and pull off so i figured since this was part 3 and Part 4 was LITERALLY the next day. A little ingenuity couldn't hurt

Starting a new JASON :)

Comments